P. Crump, S. Böldicke, C.M. Schultz, H. Ekhteraei, H. Wenzel and G. Erbert

Published in:

Semicond. Sci. Technol., vol. 27, no. 045001 (2012).

Abstract:

For maximum fibre-coupled power, high power broad area diode lasers must operate with small lateral far field angles at high continuous wave (CW) powers. However, these structures are laterally multi-moded, with low beam quality and wide emission angles. In order to experimentally determine the origin of the low beam quality, spectrally resolved near and far field measurements were performed for a diode laser with 50 µm stripe width. Within the range measured (CW optical output powers to 1.5 W) the laser is shown to operate in just six stable lateral modes, with spatially periodic profiles. Comparisons of the measured profiles with the results of two-dimensional modal simulation demonstrate that current-induced thermal lensing dominates the lateral waveguiding, in spite of the presence of both strong built-in index guiding and gain guiding. No evidence is seen for filamentation. Building on the diagnosis, proposals are presented for improvements to beam quality.

PACS:

42.55.Px Semiconductor lasers; laser diodes
42.79.Gn Optical waveguides and couplers
42.60.By Design of specific laser systems

© 2012 IOP Publishing Ltd. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IOP Publishing Ltd.

Full version in pdf-format.