20W continuous wave reliable operation of 980nm broad-area single emitter diode lasers with an aperture of 96µm

Published in:
Proc. SPIE, vol. 7198, no. 719814 (2009).
© 2009 COPYRIGHT SPIE--The International Society for Optical Engineering. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the SPIE.

Abstract:
High power broad area diode lasers provide the optical energy for all high performance solid state and fiber laser systems. The maximum achievable power density from such systems is limited at source by the performance of the diode lasers. A crucial metric is the reliable continuous wave optical output power from a single broad area laser diode, typically for stripe widths in the 90-100 µm range, which is especially important for users relying on fibered multi-mode pumps. We present the results of a study investigating the reliable power limits of such 980nm sources. We find that 96µm stripe single emitters lasers at 20°C operate under continuous wave power of 20W per emitter for over 4000 hours (to date) without failure, with 60µm stripe devices operating reliably at 10W per stripe. Maximum power testing under 10Hz, 200µs QCW drive conditions shows that 96µm stripes reach 30W and 60µm stripes 21W per emitter, significantly above the reliable operation point. Results are also presented on step-stress-studies, where the current is step-wise increased until failure is observed, in order to clarify the remaining reliability limits. Finally, we detail the barriers to increased peak power and discuss how these can be overcome.

Keywords:
diode lasers, high optical power, limitations and failure mechanisms, reliability

Full version in pdf-format.